TSE6
  • TSE1
  • TSE2
  • TSE3
  • TSE4
  • TSE5
  • TSE6

92mm Co-Rotating Twin Screw Extruder

Used twin screw extruder and auxillariles.  Please see the full specifications below. 

  • Twelve independent barrel sections water cooled
  • 92 mm screws elements are changeable for different set up's
  • 800hp  dc motor with control techniques dc drive 480v infeed
  • Torque limiting module between motor and gear box
  • Top of line henschel gear box w/water cooling and filtering
  • Siemens touch screen operation computer and monitor w/ key board
  • PSI screen changer w/ hydraulic pack 2'600 psi with nitrogen charge single slide plate w/duel breaker plate
  • Two Die's with 50 1/8 holes w/ fish tail manifold
  • Vacuum pump for venting; two vents
  • Four loss in weight feeder's computer set up ,feeder programming all with electronic fill by weight four mix tanks
  • Two side feeder's with stands w/ block plates and vent plates
  • Spare side feeder and mixing motors
  • Three vacuum feeder's one for glass' one special for talc with filtering one for pellets
  • Vacuum pump with low voltage solenoids and filtering system and piping with control panel
  • Twenty foot water bath with heat exchanger and five HP pump
  • Shear Bay dewatering unit
  • Shear Bay AX12 pellitizer
  • Eight spare rubber coated rollers Spare bearings and seals also spare bead knives
  • Spare drive belts and knurled pull rollers
  • Whitte nine feet two stage classifier
  • Spare 220 v contactors and relay's

Complete line is still under power and can be tested.  

Exclusive
Distributors of: